MIL-DTL-85052B
SAE-AMS5528
-
Steel, Corrosion Resistant, Sheet, Strip, and Plate,
17Cr-7.1Ni, 1.1Al, Solution Heat Treated, Precipitation
Hardenable. (DoD adopted)
SAE-AMS5529
-
Steel, Corrosion Resistant, Sheet and Strip,
17Cr-7.1Ni, 1.1Al, Solution Heat Treated and Cold
Rolled, Precipitation Hardenable, 0.0015 to 0.050 Inch
(0.038 to 1.27 mm) Nominal Thickness. (DoD adopted)
SAE-AMS-H-6875
-
Heat Treatment of Steel Raw Materials. (DoD adopted)
SAE-ARP1527
-
Color Coding - Elastomers for Tube Clamp Cushions
(Copies of these documents are available online at www.sae.org or the Society of Automotive
Engineers, Inc., 400 Commonwealth Drive, Warrendale, PA 15096-0001.)
2.3 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein (except for related specification sheets), the text of this document
takes precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein
and in accordance with the applicable specification sheet. In the event of any conflict between
the requirements of this specification and the specification sheet, the latter shall govern.
3.2 Qualification. The clamps furnished under this specification shall be products that
are authorized by the qualifying activity for listing on the applicable qualified product list before
contract award (see 4.2 and 6.5).
3.2.1 Qualification of molded and extruded cushions. If clamp cushions in sizes -5 and
smaller are extruded, two separate cushion qualification procedures shall be completed; one for
the extruded cushions and one for molded cushions which have wedges.
3.2.2 Qualification of the assembly. Qualification of clamps includes qualification of the
clamp elastomeric cushion and metallic band. After receiving qualification approval, cushion
material formulation and curing process shall not be changed or modified without the written
approval of the qualifying activity. Clamp band processing shall not be changed after
qualification is approved. If there are changes to the cushion material, the curing process or the
cushion material supplier, including any change in their plant location, some cushion retests may
be required, as directed by the qualifying activity. The qualification required by this
specification applies to qualification of the clamp assembly only. It does not infer qualification
of clamp installation techniques.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business