INCH-POUND
MIL-DTL-85052B
30 March 2005
SUPERSEDING
MIL-C-85052A
30 May 1984
DETAIL SPECIFICATION
CLAMP, LOOP, CUSHION, GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments and Agencies of the Department of
Defense.
1. SCOPE
1.1 Scope. This specification establishes the design and test requirements for clamp, loop,
cushion, primarily intended for general clamping of tubing for aircraft hydraulic systems.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they must
meet all specified requirements of documents cited in sections 3 and 4 of this specification,
whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications and standards. The following specifications and standards form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of
these documents are those cited in the solicitation or contract.
Comments, suggestions, or questions on this document should be addressed to the
Commander, Naval Air Warfare Center Aircraft Division, Code 491000B120-3, Highway
547, Lakehurst, NJ 08733-5100 or emailed to thomas.omara@navy.mil. Since contact
information can change, you may want to verify the currency of this address information
using the Assist Online database at https://assist.daps.dla.mil.
AMSC N/A
FSC 5340
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business