MS21122D
6. The ends of the cushion shall meet when the clamp is in the installed position.
7. Wedge is integral part of cushion.
8 The MS part number, dash number, and manufacturer's identification shall be marked on each clamp.
9. Clamps shall be furnished in the open position.
10. Dimension "0D" is applicable in closed position only.
11. Reinforced corner and stiffening bead are mandatory. Optional for -1, -2, and -3. NOTES:
1. Remove all tool and die marks, burrs and sharp edges.
2. Dimensions are in inches. Unless otherwise specified, tolerance: Decimals ± .015.
3. In the event of a conflict between the text of this standard and the references cited herein, the text of this standard shall take precedence.
4. Referenced document (or non-government) documents of the issue listed in that issue of the department of defense index of specifications and standards (DoDISS) specified in the solicitation form a part of this standard to the extent specified herein.
5. Clamp illustration and Table 1 of MS21122C have been revised to show only dimension of -1 thru -8 for clamp with CRES bands. Clamp with CRES bands for dash -1 thru -8 are inactive for new design as of
3 October 2005. Clamp with CRES bands for dash -9 thru -66 and clamp with aluminum alloy bands for dash -1 thru -66 that are not shown in this revision are cancelled after 29 May 1998. Future acquisition for these cancelled clamps may refer to Aerospace Industries Association of American Standard NAS1715. MS21122D, -1 thru -8 CRES loop clamps being reinstated as inactive for new design are .375 inches wide while NAS1715 provides only loop clamps with width of .500 inches. Table 2 provides a detailed cross- reference of cancelled MS21122 part or identifying numbers (PINs) and replacement NAS1715 PINs. Users are cautioned to evaluate replacements for their particular application.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business