MIL-DTL-85052/3C
NOTES:
Wedge shall be required on size - 6 and larger. The wedge shall be molded as an integral
part of the cushion and contoured to fit D diameter.
Stiffening bead shall be required on size - 4 and larger. All radii of the stiffening bead shall
be smooth and blended. No sharp tool marks are allowed.
Metal band shall have all burrs, sharp edges, and scale removed.
Wedge shall touch cushion on lower foot with clamp installed on mandrel without spacer.
Reference dimensions Y and J are provided to gain maximum support for the lower foot
by closely fitting the upper foot bend radius to the stiffening bead blend radius when closed
against each other.
Diameter D is the nominal diameter for which a clamp size is intended for use. Diameter
D shall be verified by the diametral retention test specified in the general specification
(see 4.4.4.1).
Dimension E shall be measured with the clamp installed on a mandrel of D diameter
+ .001, and a .0625 + .0005 spacer between the upper and lower foot as shown.
8. Unless otherwise specified, dimensions are in inches, tolerances + .03 for two decimals and
+ .010 for three decimals.
TABLE I. Clamp dimensions. 8/
Dash
C
D 6/
E 7/
R
J 5/
T
Y 5/
No.
(Ref)
Dia
+ .032
(Ref)
+ .010
(Ref)
2
.192
.125
.468
-
3
.224
.188
.499
.020
4
.255
.250
.530
.325
.090
+ .002
5
.286
.312
.561
.235
6
.318
.375
.592
7
.349
.438
.624
8
.380
.500
.655
9
.423
.562
.741
10
.454
.625
.772
.125
.032
.256
.368
11
.486
.688
.804
+ .002
12
.517
.750
.835
13
.548
.812
.866
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business