A-A-55595B
6.3 The following part or identification numbering procedure is for government purposes and does not constitute a
requirement for the contractors. The part number identification number (PIN) shall consist of the basic commercial
item description number followed by a dash number from Table I, and material code. When protective finish is
required for material A or D, add "F" to the PIN.
Example: AA55595 -12 B
Material code
Dash number
Basic number
6.4 Source of documents.
6.4.1 Department of Defense Specifications. Copies of Department of Defense specifications may be obtained from
the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094 or
online at https://assist.daps.dla.mil/quicksearch/.
6.4.2 FAR. The FAR may be obtained from the Regulatory Secretariat, 1800 F Street NW, Washington DC 20405
or online at https://www.acqnet.gov.
6.4.3 ASTM Standards. Copies of ASTM standards may be obtained from the ASTM International, 100 Barr
Harbor Drive, West Conshohocken, PA 19428-2959 or online at https://www.astm.org.
6.4.4 SAE Specifications. Copies of SAE specifications may be obtained from the Society of Automotive
Engineers, Inc., 400 commonwealth Drive, Warrendale, PA 15096-0001 or online at https://www.sae.org.
6.5 Ordering data. The contract or order should specify the following:
a.
CID document number, revision, and CID PIN.
b.
Product conformance provisions.
c.
Packaging requirements.
6.6 Key words.
Cadmium
Knuckle
Pitch
6.7 Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where
changes (additions, modifications, corrections, deletions) from the previous issue were made. This was done as a
convenience only, and the government assumes no liability whatsoever for any inaccuracies in these notations.
Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content
irrespective of the marginal notations and relationship to the last previous issue.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business