A-A-52406B
4.1 Responsibility for inspection. The contractor is responsible for the performance of all inspections (examinations and tests).
4.2 Product conformance. The products provided shall meet the salient characteristics of this commercial item description, conform to the producer’s own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial market. The Government reserves the right to require proof of such conformance.
5. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order (see 6.2).
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Part or identification number (PIN). The following part identification numbering procedure is for Government purposes and does not constitute a requirement for the contractor. The PINs to be used for clamps acquired to this CID are as follows:
AA-52406-XX
XX- Dash number (see table I)
52406- CID number
AA- Prefix letters to indicated CID
6.2 Addresses for obtaining copies of referenced documents.
6.2.1 Government publications. Copies of the Federal Acquisition Regulation (FAR) are available from https://www.acquisition.gov/far/.
6.2.2 Non-Government publications. ASTM A108 “Standard Specification for Steel Bar, Carbon and Alloy, Cold Finished”; ASTM A575 “Standard Specification for Steel Bars, Carbon, Merchant Quality, M-Grades”; ASTM A1008/A1008M “Standard Specification for Steel, Sheet, Cold-Rolled, Carbon, Structural, High-Strength Low-Alloy, and High-Strength Low-Alloy with Improved Formability, Solution Hardened, Bake Hardenable are available from www.astm.org or ASTM International, P.O. Box C700, West Conshohocken, PA 19428-2959.
6.3 Ordering data. Acquisition documents should specify the following:
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business