A-A-219A
Pins. The hinge pin shall be fast with spun or riveted ends. The pin material shall be brass or steel.
Hardware. All fasteners required for attachment shall be included with the hinges. Fasteners furnished shall be included with the hinges. Fasteners furnished shall be of the size appropriate for hinge furnished.
Workmanship. The hinges furnished shall be free from imperfections which may impair durability or serviceability.
Quality Assurance Provisions. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract or order, the contractor may use his own or any other facilities. Suitable for the performance of the inspection requirements specified herein, unless disapproved by the government. The government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure that supplies and services conform to prescribed requirements.
Sampling.
Lot. All hinges of the same size, and finish presented for acceptance at one time shall be considered a lot for purposes of inspection.
Sampling for quality conformance examination. A random sample of hinges shall be selected from each lot in accordance with Military Standard MIL-STD-105, Sampling Procedures And Tables for Inspection By Attributes.
Visual and dimensional inspection. Samples shall be selected in accordance with MIL-STD-105, special inspection level S-3, AQL 2.5 expressed in terms of percent defective. The sample hinges shall be visually and dimensionally examined to verify compliance with this specification.
Testing performance set and finish. Samples shall be selected in accordance with ANSI/BHMA A156.9. The sample hinges shall be tested in accordance with ANSI/BHMA.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business