MS27960 Hinge, Butt, Narrow Light, Non-Template

Pages 1 - 2

MS27960C

TABLE I. Dash Numbers and Dimensions

NOMINAL SIZE	A LENGTH ±.06 B WIDTH ±.06 T THICKNESS ±.005	.50 .44 .021	1.50 .87 .038	1.00 1.03 .030	2.00 1.37 .045	3.00 2.12 .064
NUMBER OF SCREW HOLES		4	4	4	6	6
1/ SIZE OF SCREW (REF)		#0	#4	#3	#5	#8
TYPE		DASH NUMBER	DASH NUMBER	DASH NUMBER	DASH NUMBER	DASH NUMBER
FAST PIN, NOT SWAGED		2	4	6	8	10

1/ SEE NOTE 1.

REQUIREMENTS:

1. Material: Body and pin: Brass, in accordance with ASTM B36/36M, UNS No. C26000, C26800, C27200, C28000 or ASTM B121/121M.

2. Protective coating. Uncoated.

3. Part number: The part number shall consist of the basic MS sheet number plus a dash number taken from table I.

Example: MS27960 -2

Dash number

Basic MS sheet number

MS27960-2 Indicates: Hinge, Butt, Length .50; Width .44; Thickness .021. NOTES:

1. Screws: Hinges are furnished with wood screws. The sizes specified are those normally furnished by the supplier. Installation determines the length of the screws.

2. All dimensions in inches, unless otherwise specified.

3. In the event of a conflict between the text of this standard and the references cited herein, the text of this standard shall take precedence.

4. Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes.

Custodians: Preparing activity: Army - AR DLA - IS

Navy - YD

Air Force - 99 (Project 5340-2009-021)

Review Activities:

Army - CR4, EA, GL Navy - MC, SH

NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https://assist.daps.dla.mil