MS20001P
a. MS20001
b. "P" for anodized finish, "C" for chemical surface treatment, omission of code letter will indicate bare finish.
c. "H", "X", or "Y" to designate half hinge style, omission of code letter will indicate complete hinge.
d. "A" for 7075-T73511 aluminum alloy hinge, omission of "A" will indicate 2024- T3511 aluminum alloy.
e. Dash number (table I), omit dash if preceded by code letter.
f. A dash followed by length "L" expressed in inches and hundredths.
7. Examples of part numbers:
MS20001-4-1200 - Complete hinge, bare finish, aluminum 2024-T3511, CRES hinge pin, 1.500 inches wide, 12.00 inches long.
MS20001CHA4-900 - Type H half hinge, chemical surface treatment, aluminum
7075-T3511, 1.500 inches wide, 9.00 inches long.
8. Do not specify "P" for anodize if hinge is to be spot welded.
9. Referenced documents shall be of the issue in effect on date of invitation for bids, or request for proposal except that referenced adopted industry documents shall give the date of the issue adopted.
10. For design feature purposes, this standard takes precedence over procurement documents referenced herein.
Changes from previous issue: The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business