MIL-DTL-43607J
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the
contract or order (see 6.2). When actual packaging of materiel is to be performed by DoD or in-house
contractor personnel, these personnel need to contact the responsible packaging activity to ascertain
requisite packaging requirements. Packaging requirements are maintained by the Inventory Control
Point's packaging activity within the Military Department or Defense Agency, or within the military
services system commands. Packaging data retrieval is available from the managing military
Department's or Defense Agency's automated packaging files, CD-ROM products, or by contacting
the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not
mandatory.)
6.1 Intended use. The padlock covered by this specification is intended for general military use with
hasps conforming to MIL-DTL-29181, and drawings listed in 3.4 herein, where a high degree of
physical security is required. The degree of security is reduced when the padlock is used without a
high security hasp.
6.2 Acquisition requirements. Acquisition documents must specify the following:
a. Title, number, and date of this specification.
b. Key requirements, if different (see 3.1 and 3.2).
c. When a first article is required for inspection and approval, and the number of units required
and instructions for disposition, if different (see 3.2 and 4.3).
d. Packaging requirements (see 5.1).
6.3 First article. When first article testing and approval is required, the first article units will be
selected and tested as specified in 3.2 and 4.1. The contracting officer should include specific
instructions in acquisition documents regarding arrangements for examination, tests, availability of
drawings of hasps required for tests, source(s) to purchase hasps for tests, disposition of bid sample
and first article units tested, and approval of the first article.
6.4 Sampling procedures.
6.4.1 Sampling for examination. Recommended inspection level is S-3 (see 4.4.1.1).
6.4.2 Sampling for tests. Recommended inspection level is S-3 (see 4.4.1.2).
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business