MIL-DTL-27536C
(This section contains information of a general or explanatory nature
that may be helpful, but is not mandatory.)
6.1 Intended use. The couplings procurable to this specification are
intended for use on fluid-line tubing joints, tailpipe joints, and accessory
mount joints, on flight vehicles or other attachments where high performance
and light weight are required and corrected loads are safely below the rated
or proof loads specified on the applicable specification sheet. The couplings
are semi-rigid and are not intended to provide fluid-line flexibility except
within the bending loads and deflections specified herein.
6.2 Acquisition requirements.
Acquisition documents should specify the
following:
a. Title, number, and date of this specification.
b. Type, size, temperature range, and applicable MS standard (see 1.2).
c. Packaging requirements (see 5.1).
d. Quantity required.
6.3
Definition.
6.3.1 Failure. Evidence of distortion, excessive deformation, elongation,
or any other malfunction detrimental to performance.
6.4 Qualification. With respect to products requiring qualification,
awards will be made only for such products as have, prior to the time set for
opening of bids, been tested and approved for inclusion in the applicable
Qualified Products List (QPL) whether or not such products have actually been
so listed by that date. The attention of contractors is called to this
requirement, and manufacturers are urged to arrange to have the products that
they propose to offer to the Federal Government tested for qualification, in
order that they may be eligible to be awarded contracts or orders for the
products covered by this specification. The activity responsible for the
qualified products list is San Antonio Air Logistics Center/MMEDO, Kelly AFB,
TX 78241, and information pertaining to qualification of products may be
obtained from that activity.
6.5
Subject term (key word) listing.
Coupling
Clamp
Flanges
V-Band
V-Grooved
V-Retainer
6.6 Changes from previous issue. Marginal notations are not used in this
revision to identify changes with respect to the previous issue due to the
extent of the changes.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business